Question 1
IntermediateMultiple answersA vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue?(Choose two.)
Answer and explanation
Correct answers: A, D
Covers troubleshooting routing, switching and overlay protocols, UCS rack and blade server issues, Fibre Channel storage troubleshooting, automation tools, and firmware and management issues.
17 free sample questions240 in the full practice test

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue?(Choose two.)
Correct answers: A, D
A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Cisco Nexus7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?
Correct answer: C
After a vPC failover, Switch-B holds the operational primary role. To manually preempt the operational primary role back to Switch-A, an engineer changes the vPC role priority on Switch-B and then shuts down and re-enables the vPC peer link. Which role-priority change must be made on Switch-B?

Correct answer: B
Cisco's vPC election document says vPC roles are non-preemptive: when the primary fails, the secondary becomes operational primary, sets its sticky bit, and keeps that role after the old primary returns. The election compares the sticky bit, then the user-defined role priority (the lowest numeric value wins), then the lowest system MAC address. To make one device primary again, Cisco says to give that device the lower role priority and the other device the higher value, then shut down and re-enable the vPC peer link. So on Switch-B the role priority must be set higher than Switch-A's; changing or re-entering the role priority also clears Switch-B's sticky bit, and the peer-link flap re-runs the election in Switch-A's favor. A lower value would make Switch-B win again, and the same value would leave the result to the system MAC addresses. Source: Cisco, 'Understand the vPC Election Process' (document 212589).
Refer to the exhibit. An OSPF adjacency between Router-A and Router-B fails to reach the FULL state. Which action resolves the issue? A.Adjust the MTU on Router-A to 1600.B.Disable the check of the MTU value.C.Set the OSPF media type to point-to-point.D.Adjust the MTU on Router-B to 1604.

Correct answer: B
The Cisco Nexus switch is connected to a peer switch that is not running Cisco NX-OS. The switches are connected using port channel and are experiencing packet loss. Which action should be performed on the Cisco Nexus switch ports to resolve this issue?
Correct answer: C
Refer to the exhibit. The HSRP configuration in the exhibit fails to function. Which action resolves this issue?

Correct answer: C
Refer to the exhibit. The HSRP instance on both switches is showing as active. Which action resolves the issue?

Correct answer: B
An engineer troubleshoots a fabric discovery failure. Which two requirements about switch connectivity must be verified to solve the problem? (Choose two.) A.A Cisco APIC must be attached to a spine node only.B.A Cisco APIC must be attached to leaf nodes.C.Spine nodes must connect to other spine nodes.D.A Cisco APIC must be dual-attached to two separate spine nodes.E.Leaf nodes must connect to spine nodes only.
Correct answers: B, E

Or unlock all 240 300-615 questions with explanations, timed mode and flashcards.